Juniper SRX3600 Hardware Manual page 57

Cables and Two XFP sockets for Ethernet transceivers
connectors
Supported XFP transceivers:
10GBASE-ER (model numbers SRX-XFP-10GE-ER and SRX-XFP-10GE-ER-ET )
10GBASE-LR (model numbers SRX-XFP-10GE-LR and SRX-XFP-10GE-LR-ET
10GBASE-SR (model numbers SRX-XFP-10GE-SR and SRX-XFP-10GE-SR-ET )
Controls ONLINE Button–The ONLINE button on the IOC front panel does not perform any function.
Supported Slots
NOTE:
known as Services Offload) mode supported in Junos OS release 12.1X44-D10 and later,
IOCs are only supported in front panel slots 1 through 3. See the Junos OS documentation
for more information about Express Path mode.
Swapping IOCs are cold-swap-only modules. You must power-off the services gateway before
removing, replacing, or adding IOCs.
LEDs SERVICE LED, one bicolor
OK/FAIL LED, one bicolor
SRX1400: Front slot labeled 2
SRX3400: Front slots labeled 1 through 4 (except as noted below)
SRX3600: Front slots labeled 1 through 6 (except as noted below)
When an SRX3400 or SRX3600 Services Gateway is in the Express Path (formerly
Off–The IOC is administratively disabled, butmapped to the NPC.
Green–The IOC is mapped to the NPC and is available to carry Ethernet traffic.
Amber–The IOC is not mapped to the NPC and is not available to carry Ethernet traffic.
Off–One or more of the following conditions apply:
The services gateway is not powered on.
The services gateway is still in the process of either booting or shutting down.
The services gateway is not configured for chassis clustering.
Steady Green–The services gateway is configured for chassis clustering, and the SCM
is operating normally.
Blinking Green–The SCM is initializing (preparing to come online) or is preparing to go
offline.
Red–The SCM has failed and is not operating normally.
41