4
Plastic
Cover
Protruding Side
#8 x 32 Nut
• Insert a screw through the outside of each plastic cover and tighten
with a Phillips screwdriver. Do not over-tighten.
• Pull up on the seat back wire to be sure it is secure. If you can remove
either end of the seat back wire, you have not assembled it correctly.
Remove the screws, re-read and repeat Assembly steps 3 and 4.
ASSEMBLY
• Fit the nut (so that the protruding side
is facing the seating area) into the
hexagonal opening on the inside of
each plastic cover.
8
Pull Up