Download  Print this page

Makita BV4500-118 Instruction Manual

Lockbolt/blind rivet installation tool.
Hide thumbs
   

Advertisement

INSTRUCTION MANUAL
Lockbolt/Blind Rivet Installation
Tool
BV4500-118
IMPORTANT: Read Before Using.

Advertisement

Table of Contents

   Also See for Makita BV4500-118

   Related Manuals for Makita BV4500-118

No related manuals

   Summary of Contents for Makita BV4500-118

  • Page 1 INSTRUCTION MANUAL Lockbolt/Blind Rivet Installation Tool BV4500-118 IMPORTANT: Read Before Using.
  • Page 2 SPECIFICATIONS Model: BV4500-118 Pulling force 20 kN Stroke 30 mm (1-3/16") Overall length 358 mm (14-1/8") Rated voltage D.C. 18 V Net weight *** - *** kg (*** - *** lbs) without notice. est combination, according to EPTA-Procedure 01/2014, are shown in the table.
  • Page 3 turning the power tool on. clean and free from oil and grease. handles and grasping surfaces do not allow for safe handling and control of the tool in unexpected situations. Do not overreach. Keep proper footing and When using the tool, do not wear cloth work balance at all times.
  • Page 4 When operating the tool, do not block or seal the ventilation windows of the tool. Symbols SAVE THESE INSTRUCTIONS. CAUTION: Only use genuine Makita batteries. Use of non-genuine Makita batteries, or batteries that volts direct current charger. Tips for maintaining maximum Important safety instructions for...
  • Page 5 Indicator lamps Remaining capacity Lighted Blinking 25% to 50% 0% to 25% Charge the Fig.1 malfunctioned. 1. Red indicator 2. Button 3. while sliding the button on the front of the cartridge. NOTE: Depending on the conditions of use and the Tool / battery protection system CAUTION: Always install the battery cartridge...
  • Page 6 the switch trigger. To change the value, press button C. To change the digit, press button B. To set the value, press button A for a few seconds. The value can be set between "-99" and "0". NOTE: The larger the value becomes, the tighter the nose piece becomes.
  • Page 7 Installing or removing the pulling unit (nose assembly) perform the removal procedure in reverse. Loosen the nut of the anvil holder, and then remove the anvil holder. Fig.9 2. Joint Hook CAUTION: Always remove the battery when hanging the tool with the hook. Fig.6 CAUTION: Never hook the tool at high loca-...
  • Page 8 piece. Fig.11 1. Mandrel container Fig.13 1. Blind rivet 2. Nose piece You can install the cap instead of the mandrel container. Press the tool tip against the workpiece, and then pull the switch trigger. After the mandrel is broken off, release the switch trigger.
  • Page 9 To maintain product SAFETY and RELIABILITY, OPTIONAL ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool accessories or attachments might present a risk of for its stated purpose. Center. NOTE: 9 ENGLISH...
  • Page 10 Para reducir la exposición a estos productos químicos: trabaje en un área bien ventilada y póngase el equipo de seguridad indicado, tal como las máscaras contra polvo que están especialmente diseñadas para filtrar partículas microscópicas. Makita Corporation 3-11-8, Sumiyoshi-cho, 885658-941 Anjo, Aichi 446-8502 Japan...

Comments to this Manuals

Symbols: 0
Latest comments: