Makita BV4500-118 Instruction Manual page 5

1
2
Fig.1
1. Red indicator 2. Button 3.
while sliding the button on the front of the cartridge.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
CAUTION:
Do not install the battery cartridge
forcibly.
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
Fig.2
1. Indicator lamps 2. Check button
light up for a few seconds.
Indicator lamps
Lighted Off
3
1
2
-
Remaining
capacity
Blinking
75% to 100%
50% to 75%
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
Tool / battery protection system
placed under one of the following conditions:
Overload protection
the tool off and stop the application that caused the tool
to become overloaded. Then turn the tool on to restart.
Overheat protection
Overdischarge protection
Switch action
WARNING:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
5 ENGLISH
Off Blinking
malfunctioned.
Remaining
capacity
25% to 50%
0% to 25%
Charge the
-
-
-