Makita BV4500-118 Instruction Manual page 7

Installing or removing the pulling
unit (nose assembly)
perform the removal procedure in reverse.
1. Loosen the nut of the anvil holder, and then
remove the anvil holder.
1
Fig.6
1. Anvil holder 2. Nut
2. Loosen nut A and nut B with two wrenches.
Fig.7
1. Nut A 2. Nut B
NOTICE:
When installing the pulling unit (nose
3. Loosen nut A with a wrench while holding the nose
adapter with another wrench.
1
Fig.8
1. Nut A 2. Nose adapter
4.
2
2
1
1
Fig.9
1.
Hook
CAUTION:
hanging the tool with the hook.
CAUTION:
tion or on potentially unstable surface.
CAUTION:
hook, hang it carefully.
1
2
3
Fig.10
1. Groove 2. Hook 3. Screw
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Installing or removing the mandrel
2
container
NOTICE:
or the cap to the tool before operating the tool. If
the mandrel container or the cap is not installed
to the tool, the tool will not operate.
To remove the mandrel container, rotate it counter
clockwise.
7 ENGLISH
2
2. Joint
Always remove the battery when
Never hook the tool at high loca-
When hanging the tool with the
Be sure to install the mandrel container
1
2
3