Invacare Cadiz Series User Manual page 2

Assembling the Shower Chair
Installing/Adjusting the Leg Extensions
Ensure that the shower chair is level and stable before use.
D
1. Allow the shower chair adjust to room temperature, if
necessary.
Place the seat A upside down on a flat, stable surface (floor or
2.
table).
Install the leg extension B onto the leg C.
3.
Press the snap button D and slide the leg extension up or
4.
down to the desired adjustment hole E.
5. Ensure the snap button protrudes fully through the
adjustment holes of the leg extension.
NOTE: There will be an audible click when the snap button fully engages.
6. Repeat STEPS 2-5 for the remaining three legs.
NOTE: Make sure that all four legs are adjusted to the same height.
Invacare® Cadiz
WARNING
E
C
B
Installing the Backrest - Model H296 Only
B
A
1. Put the shower chair on its side on a flat, stable surface.
Press the snap buttons A on the back support tubes B and
2.
slide the back support tubes into the back support brackets C.
3. Ensure both snap buttons are fully engaged inside the holes in
the back support brackets.
NOTE: There will be two audible clicks when the snap buttons fully
engage.
Using the Shower Chair
Risk of injury. DO NOT lift the shower chair while the user is
seated. The backrest can get loose and injury or damage may
occur.
2
C
WARNING
Part No 1176099
A