Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Vents PU JK 01
Summary of Contents for Vents PU JK 01
- Page 1 USER’S MANUAL PU JK 01 LCD Control Panel...
-
Page 2: Safety Requirements
PU JK PU JK CONTENTS Safety Requirements Main Technical Data Panel Mounting Panel Operation Factory Settings SAFETY REQUIREMENTS • Read the user’s manual carefully prior to the operation and installation of the control panel. • Installation and operation of the control panel shall be performed in accordance with the present user’s manual as well as the provisions of all the applicable local and national construction, electrical and technical codes and standards. -
Page 3: Main Technical Data
MAIN TECHNICAL DATA PARAMETER VALUE Ambient Temperature [°C] From +5 to +40 Relative Humidity [%] From 5 to 80 (no condensation) Recommended cable cross section [mm 0.22 - 0.25 Material Plastic Dimensions (WхHхD) [mm] 86х86х13 Cable Length [m] Up to 15 IP Code IP20 PANEL INSTALLATION... -
Page 4: Control Panel Operation
PU JK PU JK CONTROL PANEL OPERATION CONTROL PANEL BUTTON FUNCTIONS Wall-Mounted Control Panel Remote Control Unit On / Off Fan Speed Up Heater On Heater Off Medium Speed Fan Speed Down Activation High Speed Activation Low Speed Activation Bypass Control Timer On / Off Unit On / Off Button Unit Mode Control... - Page 5 2. Ventilation Unit Mode Control. The speed of the ventilation unit fans is controlled using: The control panel: Press the button to increase the speed or the button to reduce the speed of the unit fans (Low Speed - Medium Speed - High Speed - Humidity Feedback Control). The remote control: Press the button to increase the speed or the button to reduce the speed of the unit fans...
- Page 6 PU JK PU JK 6. Timer On / Off The timer is used to switch the fans to the speed defi ned in the service menu («Timer Mode Air Flow» parameter) with an automatic return to the previous speed after a set time period.
- Page 7 Use the buttons to select the parameter code for editing and set the desired value by means of the buttons. The parameter codes are detailed in the table below (Page 12). 10. Timer Setup. To set the timer enter the Service Menu and use the button to select the Date and Time Setup mode.
- Page 8 PU JK PU JK 14. Humidity Feedback Control Activation. To enable humidity feedback control enter the service menu and use the button to select the humidity feedback control activation mode. While in the humidity feedback control activation mode the indicators on the control panel display are blinking.
-
Page 9: Factory Settings
FACTORY SETTINGS Parameter Measurement Measurement Default Parameter Purpose Code Units Range Value Duct Temperature °С 10-30 Temperature in the air duct. Room Temperature °С 10-30 Room temperature. Timer Operation - Temperature °С 10-40 Room temperature for timer operation. Timer Operation - Air Flow. 1, 2, 3 Ventilation mode for timer operation. - Page 10 V55-5EN-02(1)
Need help?
Do you have a question about the PU JK 01 and is the answer not in the manual?
Questions and answers