Safety Requirements - Vents PU JK 01 User Manual

2
CONTENTS

SAFETY REQUIREMENTS

• Read the user's manual carefully prior to the operation and installation of the control panel.
• Installation and operation of the control panel shall be performed in accordance with the present user's manual as well as the
provisions of all the applicable local and national construction, electrical and technical codes and standards.
• The warnings contained in the present user's manual must be considered most seriously since they contain vital personal safety
information.
• Failure to follow the safety regulations may result in an injury or control panel damage.
• Read the manual carefully and keep it as long as you use the control panel.
• While transferring the equipment control the user's manual must be turned over to the receiving operator.
The control panel must be disconnected from
power supply prior to every installation or
repair operation.
Do not position any heating devices or other
equipment in close proximity to the control
panel power cord.
While installing the control panel follow the
safety regulations specifi c to the use of electric
tools.
Do not change the power cord length at your
own discretion.
Do not bend the power cable.
Avoid damaging the power cable.
Do not touch the control panel with wet hands.
Do not carry out the control panel maintenance
with wet hands.
Do not let children operate the panel.
In case of unusual sounds, smoke disconnect
the control panel from power supply and
contact the service centre.
Safety Requirements
Main Technical Data
Panel Mounting
Panel Operation
Factory Settings
SAFETY PRECAUTIONS DURING INSTALLATION AND OPERATION
PU JK PU JK
2
3
3
4
8
The control panel must not be operated
outside the temperature range stated in the
user's manual or in aggressive or explosive
environments.
Do not use damaged equipment or
conductors to connect the panel to the
power mains.
Unpack the panel with care.
Use the panel only as originally intended.
Avoid penetration of water onto the electric
parts of the panel.
ON
The control panel must be disconnected
from the power supply prior to maintenance
operations.
OFF
Keep the power cord intact while operating
the control unit.
Do not put any foreign objects on top of the
power cord.