Assembly; Preparation; Required Tools - tepro LAREDO Operating Manual

t
Device-specific instructions for use
as a fireplace
– If installed indoors, the fireplace may
be used for decorating purposes only.
Operating the device indoors is not
permissible.
– Do not use the fireplace underneath a
canopy.
– Safe operation of the fireplace is only
guaranteed when it is positioned on
a firm, level, and sufficiently stable
surface.
– Only use dry lighters or special grill
lighter fluids according to EN 1860-3 for
lighting. Observe all instructions from
the manufacturer.
– Never use liquids such as petrol,
turpentine, denatured alcohol, etc. for
lighting or re-lighting. Such substances
ignite explosively and are to some
extent poisonous. Use a dry lighter or
chimney starter instead.
– When adding fuel, wear heat-resistant
gloves (e.g. oven mitts).
– Wear sturdy, closed shoes. Sandals do
not provide any protection against hot
charcoal pieces!
– Never leave open fire or embers
unattended. Risk of injuries and fire!
– Always have a bucket of sand ready
for extinguishing fires in case of
emergency.
– Put the remaining charcoal and ashes
into a non-flammable metal container
and then fill this container to the top with
water. Leave the charcoal and water in
the metal container for 24 hours before
disposal.
– Only use well-dried wood (storage period
of at least 3 years) or commercially
available briquettes.
20
P1701031-TEPRO_1069_Laredo_FP_DE_GB.indb 20
– Take your neighbours into consideration,
so that smoke or odours will not disturb
them and their property does not get
endangered.

Assembly

Preparation

Danger Risk of injury!
Failure to follow these
instructions can lead to
problems and risks while using
the fireplace/grill.
– Follow all of the assembly instructions
listed here.
1. First read through the assembly
instructions completely.
2. Take sufficient time for the assembly
and establish an even work surface of
one to two square metres.
3. Small parts such as handles will
probably be preassembled.
4. Look out for sharp corners and wear
protective gloves for assembly.

required tools

1 x Phillips screwdriver
9/6/2017 11:31 AM