XONOX CT 200 Quality Assurance Document page 3

9) Now you can check the alignment of the mechanical axis: Lead the upper and lower
shaft together and move the measuring sleeve over the shafts.
10) When the alignment of the axis are correctly, the measuring sleeve can be moved
without chopping.
11) Control the orientation to the chuck: Clamp the measuring sleeve in the chuck and let
the upper and lower shaft glide into the measuring sleeve. For this action, the upper
boom can be held by hand and the lower boom can be operated with the pneumatic
(left) switch. When you see that the lower shaft entering into the measuring sleeve,
lead the upper shaft by hand in the measuring sleeve.
12) When the alignment is centered, both shafts slide into the
know that you are measuring centrically in the middle.
measuring sleeve. Now you