Error Messages On The Screen - Fujitsu LIFEBOOK E549 Operating Manual

Troubleshooting and tips

Error messages on the screen

Errors Error messages onthescreen
This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programs are described in the documentation for these programs.
If the error message appears repeatedly despite troubleshooting measures,
contact the place of purchase or our customer service center.
Error message/cause
CMOS Battery Bad
If the error message occurs repeatedly, the
back-up battery in the notebook is dead.
System CMOS checksum bad - Default configuration
used
The system configuration information is
incorrect.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory. an error
has resulted at the address xxxx.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
Keyboard controller error
Keyboard error
nn Stuck key
Operating system not found
Press <F1> to resume, <F2> to SETUP
This error message appears if an error occurs
during the self-test before starting the operating
system.
82
Troubleshooting
► Contact your sales outlet or our customer
service center.
► Switch the notebook off.
► Switch the notebook on.
► Press the function key
BIOS Setup.
► In the BIOS Setup, select the Exit menu.
► Select the entry Load Setup Defaults.
► Select OK and press the Enter key.
► Check whether the additional memory
module has been inserted correctly.
► Start the BIOS Setup (Primary Master
submenu) and select the correct settings.
► Switch off the notebook with the ON/OFF
button.
► Wait 3 - 5 seconds and switch on the
notebook again.
If you use an external keyboard:
► Check the connection and reboot the
notebook.
► Make sure that no key is pressed.
► Check in the BIOS Setup whether your hard
disk has been set correctly.
► Make sure that the operating system is
installed on the corresponding drive.
► Press the F1 function key to start the
operating system.
► Press the function key
BIOS Setup.
F2 to access the
F2 to access the
Fujitsu