Mounting The Ng3 Panel On The Frame; Adcp - ADC NG3 User Manual

2.2

Mounting the NG3 Panel on the Frame

Use the following procedure to mount any NG3 panel on the NG3 frame:
1. Determine where the panel will be located on the frame.
2. Align the mounting holes in the panel with the mounting holes in the frame as shown in
Figure
SLACK
STORAGE
SPOOL
3. Secure the panel to the frame using the four screws and washers provided with the panel.
4. Record the panel number and/or connector type on the general purpose label provided on
the front of the panel.
7.
LOWER
TROUGH
AFFIX PANEL NUMBER
GENERAL
LABEL HERE. LABEL
PURPOSE
SHEET PROVIDED
LABEL
WITH FRAME.
Figure 7. Mounting the Panel on the Frame
NG3
PANEL
© 2006, ADC Telecommunications, Inc.
ADCP-90-297 • Issue 7 • July 2006
REAR
TROUGH
FRAME
18297-B
Page 9