HiB Velocity Manual

Download this manual

Velocity, Photec & Vector Cabinets

Velocity

Photec

Vector

Art No. 43100

Art No. 43200

Art No. 44400

Thank you for purchasing this HiB product.

Please read through these instructions carefully and refer back to them during installation to ensure that

your product is fitted safely and that it retains its high quality finish.

Please retain this leaflet for future reference.

Before drilling, ensure there are no hidden cables or pipes in the wall.

Please Note You may need to remove the door(s) to aid installation. This can be done by unclipping the

hinges. (There is a release catch at the back of the hinge).

DO NOT FIT SHELVES AT THIS STAGE.

Please do not lift the product up by the plastic diffusers as this may cause damage

to your product.

These products must be installed with a minimum distance of 150mm between

the infra-red sensor switch and any surface or object to ensure correct operation

of the sensor.

Min. 150mm

#02 006 R150908

Ver No.

1.0 Jan 2016

Need help?

Do you have a question about the Velocity and is the answer not in the manual?

Page 1 Art No. 43200 Art No. 44400 Thank you for purchasing this HiB product. Please read through these instructions carefully and refer back to them during installation to ensure that your product is fitted safely and that it retains its high quality finish.
Page 2 REAR VIEW Mounting Points location of internal ﬁxing hole Angle Adjustment Claw In/Out Claw In/Out Adjustment Adjustment Fixing Preparation (Fig A) Fixing Brackets (Fig B) Hanger Adjustment (Fig C) Wall Hung Installation specialist fixings should be purchased from any DIY or hardware store. 1.
Page 3: Operating Instructions
LED driver Rewire the cabinet as shown in the diagram anti-clockwise to remove the lamp from the above. HiB recommends that all electrical lamp holder. bathroom products should only be fitted by a 4. Carefully push the replacement lamp into suitably qualified, Part P registered electrician.
Page 4 ©HiB Copyright: No part of this document may be reprinted or duplicated without HiB consent. All sizes and measurements are approximate, but we do try and make sure they are as accurate as possible. In the interest of continuous product development, HiB reserves the right to alter specifications as necessary. E & OE.

PhotecVector