Connecting Devices Via Bluetooth - auna multimedia 10027746 Manual

Connecting Devices via Bluetooth

• Press power button until you hear a sound and the blue light blinks, which iudicates Sound Box is already con-
nected with tile device as it did last time. And then long press power button until you hear a sound twice and
see red and blue lights blink alternately, you may use your smartphone to directly pair the Sound Box when it
appears on the list of your Bluethooth device
• In working status, press power button until you hear a sound twice and see the red light turns on, which indica-
tes Sound Box is shutting down.
• While Sound Box is playing music via Bluetooth, the music will pause and you will hear the ringtone in case of
any incoming call. You may press Hands-Free Talking to answer the call, and then press it again to end this call
so that the product will continue to play music. You may also long press Hands-Free Talking for 2 second to
decline the incoming call and the product will continue to play music.
• Long press VOL+ for several times to increase the volume, which will reach tile maximum value wilen you will
rat-tat sound.
• Long press VOL- it for several times to decrease the volume, which will reach the minimum value when you will
rat-tat. sound.
• Press VOL+/NEXT track button, Sound Box will play the next song. Press VOL-/Previous track button, Sound Box
will play the Previous song.
• The sound volume can also be controlled by using smart phone or other Bluetooth device.
• Once you hear „toot. toot . . . „ while playing music, please charge up Sound Box immediately.
• In charging status, the red light is on: once fully charged, the red light goes out.
• In order to maintain battery capacity, please fully discharge and charge the battery every three months whether
you use it or not during such period.
Connect the Sound Box to Bluetooth Device
As there are many Bluetooth products in the market, it is not possible to elaborate one by one, here we just give
us the demo on how to connect Sound Box to iPhone via Bluetooth.
*Please enter 0000 if password is required.
*Please follow the instructions set out in iPhone user manual.
Before connecting Sound Box to iPhone, please make sure Bluetooth is enabled and no other audio device is con-
nected via line in port in Sound Box.
1. Press Bluetooth button for several seconds until you see red and blue lights blink alternately.
2. Turn on your iPhone.
3. Turn on Bluetooth with your iPhone as per below steps: Settings > General > Bluetooth. Turn it on and your
iPhone starts searching other Bluetooth devices nearby and will list them all once finishing searching: Sound
Box is supposed to be on the list and not connected;
4. Pair your iPhone with Sound Box, and you will see the prompt on the screen once they are connected. When
the blue light blinks, Sound Box wilt play music as per remote control of iPhone.
5. In case Sound Box is powered off, please press power button for reboot and turn on Bluetooth again so that
it will automatically start connecting to the device as it did last time and the red light will blink. Once they are
connected, the red light turns blue.
*In case any audio device is connected via line in port, Sound Box will play music saved on such audio device
instead of that saved in Bluetooth device. In order to resume music in Bluetooth device, please disconnect audio
device.
9