Advertisement
TVM PRO Television Wall Mount
3c) Place platform on top of platform swivel bracket, with platform tilt
screws passing through slots on platform as shown. Turn front edge of
platform at right angles to support arm, as shown. Insert small hex wrench
through holes in bottom of platform support, and thread platform tilt screws
into threaded ends of platform slide bar (7). using small hex wrench (11),
as shown.
Step 4
Insert support arm into wall bracket. Thread 3/8" pivot bolts
into support arm, and secure with large hex wrench.
Do not over tighten lock nut, or arm will not swing freely.
Snap wall bracket cover into place.
Note: If using the optional TVC component mount, install it at this time.
Step 5
Thread open end of security strap (19) up through a slot on the outer edge of platform, across the platform, and then
down through the other slot. Place TV squarely onto platform.
Optional: Bolt TV to the platform by passing security screws (not supplied) through grid on bottom of platform into
threaded lands on bottom of TV.
Note: You must consult the TV manufacturer for the correct size and length of bolts to use for your make/model of
television. Failure to do so may result in damage to the TV.
Step 6
Adjust platform for desired amount of tilt:
To increase tilt angle, hold top of TV and carefully push front edge of platform backwards.
To decrease tilt angle, hold top of TV and carefully pull front edge of platform forwards.
With tilt angle set, turn front edge of platform at right angles to support arm. Insert small hex wrench
through holes in bottom of platform support as shown, and tighten tilt screws securely.
Step 7
If desired, press nose piece (5) into place at end of support arm, as shown.
Pull two ends of security strap over TV, thread strap ends through strap buckle (as shown),
and secure tightly.
OmniMount Systems, Inc.
th
8201 S. 48
1-800-MOUNT-IT • www.omnimount.com
Street • Phoenix, AZ 85044
Advertisement
