Safety Instructions - Sander XT2000 User Manual

Safety instructions

The use of the ozonizer occurs at your
!
own risk.
The ozonizer may not come into
contact with water.
Free ozone is hazardous by inhalation.
To avoid release of excess ozone, it
must only be produced in the quantity required
by the application. The threshold limit value
(TLV, or maximum acceptable workplace
concentration) for ozone is 0.1 ppm (200 μg/
m³). However, the odour detection threshold
for ozone is 5 to 10 times lower (about
0.02 ppm). Detection of ozone odour is a sign
of excess ozone generation. Excess ozone (eg.
from a skimmer's exhaust) must be released
into the outside air or fed into a residual ozone
absorber.
The ozonizer requires an airflow of no
less than 75 litres per hour. Reduced
airflow may cause the ozone generator to
overheat. The ozonizer will detect insufficient
airflow and automatically shut off ozone
production to avoid overheating.
The ozonizer may be used by children
from age 8 — as well as by persons
with reduced physical, sensory or mental
capabilities, or insufficient experience and
knowledge — only under supervision, or if
instructed on the safe use of the ozonizer,
and if they are aware of and understand the
potential hazards. Children may not play with
the ozonizer. Maintenance and cleansing tasks
may be performed by children only under
supervision.
Do not open the ozonizer's casing.
Improper repair work or other
modifications may create considerable hazards.
In the event that your ozonizer requires
repair or other servicing, please contact your
specialist supplier or refer directly to the
manufacturer.
Do not operate the ozonizer if it is
damaged. Damaged ozonizers may
pose considerable hazards to the user.
The ozonizer may only be operated
with the original power supply unit
(item designation GS60A24-P1J, 24 volts,
2.5 ampères, 60 watts).
The surfaces of the ozone generator
may be hot. Before performing any
maintenance or cleansing tasks, please allow
the ozonizer to cool.
Warranty and liability
!
exclusion
There is a 24-month warranty for all Sander-
manufactured ozonizers. During this time, all
parts that fail due to material or manufacturing
defects are replaced at no cost.
Please note that the warranty does not cover
the following types of failure or damage:
⇒ Failure or damage due to unintended use.
This specifically includes any use not covered
by these instructions.
⇒ Failure or damage due to improper repair
work, modifications, cleansing, opening of
the ozonizer casing, etc.
⇒ Failure or damage due to improper transport,
drop or shock, etc. after the date of
purchase.
The warranty and liability offered
by the manufacturer (Erwin Sander
Elektroapparatebau GmbH) only covers the
package contents.