Check The Condition Of The Battery; Check The Product Operates Correctly; Check The Barking Detection Sensitivity Adjustment - Num'axes CANICALM Premium Technical Support

Check the condition of the battery.

To check the condition of the battery, you have to press the button located inside the collar
(see diagram above).
If the collar emits a continuous beep sound when you press the button, the battery is
weak.
Replace it with a new one of the same type (lithium 3-V CR2) paying attention to follow
polarity indicated on the battery housing.
Due to greater use during your dog's training, the first battery may not last as long as
replacement batteries.
NUM'AXES advises to use the same type and same brand of batteries as those
supplied in your new purchased product. Other brand of batteries may not
operate, or may not be completely compatible with your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.

Check the product operates correctly.

When leaving the factory, the bark control collar is set on mode 2 (beep sounds + light
stimulations).
4 operating modes are available on each collar (see paragraph "Change the operating
mode" below).
You can check the collar is operating properly at any time using the following procedure:
 Before doing so, make sure the collar is turned Off (battery removed from its
housing).
 You can then fix each wire of the neon test lamp under each contact point
(unscrewing them lightly and retightening them so as to pinch the test lamp wires).
 Switch on the collar (battery in place)
 Make a streaked object (ex. knife with teeth with isolated sleeve) slide on one of the
contact points (change the barking detection sensitivity if necessary).
 In operating mode 1 "beep sounds only", the collar must emit beep sounds and the
test lamp must not light.
 In operating modes 2, 3 or 4 "beep sounds + stimulations", the collar must emit
beep sounds and the test lamp must light.
 Before disconnecting the test lamp, make sure the collar is turned Off (battery
removed from its housing.

Check the barking detection sensitivity adjustment.

Setting the barking detection sensitivity is a very important operation. In fact, this setting
determines the correct operation of the collar. It ensures detection of any barking but helps
avoid unnecessary triggering.
The detection must therefore be sufficiently sensitive but not overly sensitive.
When leaving the factory, detection sensitivity is set on the medium position (medium
sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, your should proceed
as follows:
 Remove the 4 screws from the battery cover.
 remove the battery cover.
www.numaxes.com
CANICALM Premium technical support
2/5