Purpose Of Use; Technical Specifications; Important Rules - Redring MS6 Installation & Operating Manual

This electric water heater complies with the requirements of EN 60335-1,
EN 60335-2-21.

PURPOSE OF USE

The appliance is designed to supply hot water to household facilities
equipped with a plumbing system operating with pressure not greater than
6bar.
It is designed to operate only in closed and heated premises where the air
temperature is not lower than 4
continuously.

TECHNICAL SPECIFICATIONS

Nominal volume
Nominal voltage
Nominal power c onsumption - 1500 watts
Nominal pressure
ATTENTION!
This is not the water mains pres s ure. This is the pressure that is
rated for the appliance and refers to the requirements of the safety
standards.
Water heater type
Inner coating:
Daily energy consumption
Rated load profile
Quantity of mixed water at 40
Maximum temperature of the thermostat
Default temperature settings
Energy efficiency during water heating

IMPORTANT RULES

DO NOT switch the electrical supply on to the water heater until you are
sure that it is filled with water.
A suitably qualified person must perform the connecting of the water
heater to the water supply.
A suitably qualified electrician must perform the connecting of the water
heater to the power supply, if the plug is not used. (See page 11 for
colour codes)
Connecting the water heater to the electric mains via a plug must only
use the plug supplied.
If the water heater will not be used for longer than 3 days and the
temperature in the premises could drop below 4
heater must be drained to avoid any possible damage of the appliance.
°
C and it is not designed to operate
- 6Iitres
- 230-240V AC
- 6bar
closed accumulating water heater, with thermal insulation
°
C 6 litres
3
Glass-ceramic
- see Annex I
- see Annex I
- see Annex I
- see Annex I
- see Annex I
- see Annex I
°
C, the water in the water