Trouble Shooting - Defy ACPHP 12K Remote Control Manual

Trouble shooting

7
Please review this list before calling a service centre. It could save you time and money. This
list includes frequent complaints that do not arise from defective workmanship or material
usage. Some of the features described here may not apply to your model.
Problem
There is no electricity.
The overflow indicator displays
"FL".
The ambient temperature is too
low or too high
The air
In cooling mode, the room
conditioning
temperature is lower than the set
does not work.
temperature; in heating mode, the
room temperature is higher than
the set temperature.
In dehumidification mode, the
ambient temperature is low.
There is direct sunlight.
Doors or windows are open; there
are a lot of people; or in cooling
The cooling
mode, there are other sources of
effect is not
heat.
good
The filter screen is dirty.
The air inlet or outlet is blocked.
The air conditioning is not placed
Big Noise
on a flat surface.
compressor
Overheat protection starts.
does not work.
The distance between the
machine and the remote control is
The remote
control does not
The remote control is not aligned
work.
with the direction of the remote
Batteries are dead.
Displays 'E1'. The pipe temperature sensor is
abnormal.
Displays 'E2' The room temperature sensor is
abnormal.
Reason
Page 16
Solution
Turn it on after connecting it to a socket
with electricity.
Discharge the water inside.
Recommend to use the machine in at
the temperature of 7-35 ºC
Change the set temperature.
The machine is placed in a room with an
ambient temperature of greater than
17ºC
Pull the Curtain.
Close doors and windows, and add new
air conditioning.
Clean or replace the filter screen.
Clear obstructions.
Put the air conditioning on a flat and
hard place (to reduce noise).
Wait for 3 minutes until the temperature
is lowered, and then restart the machine.
Let the remote control get close to the
air conditioning, and make sure that the
remote control directly faces to the
direction of the remote control receiver.
Replace batteries.
Check the pipe temperature sensor and
related circuitry.
Check the room temperature sensor and
related circuitry.