Water Drainage - Defy ACPHP 12K Remote Control Manual

Protection Functions
Frost Protection Function
In cooling, dehumidifying or economic power saving mode, if the temperature of the exhaust
pipe is too low, the machine will automatically enter protection status; if the temperature of the
exhaust pipe reaches a certain temperature, it automatically reverts to normal operation.
Overflow Protection Function
When water in the water pan exceeds the warning level, the machine will automatically sound
an alarm, and the "FULL" indicator light will flash. At this point, you need to move the drainage
pipe connecting the machine or the water outlet to sewer or other drainage area to empty the
water (See drainage instructions). After the water is emptied, the machine will automatically
return to the original setting.
Automatic Defrosting (Heating and cooling models have this function)
The machine has automatic defrosting function.
Automatic Thermal Protection:
The machine has an automatic thermal protection in heating mode. During the protection
period, the compressor and the lower motor will stop operating and will automatically return to
normal heating state after the temperature of the machine has normalised.
Protection Function of the Compressor
To increase the service life of the compressor, it has a 3-minute delay booting protection
function after the compressor is switched off .

Water drainage

Manual drainage:
1) When the machine stops after the water is full, turn off the machine power and unplug the
power plug.
Note: Please move the machine carefully, so as not to spill the water in the water pan at the
bottom of the body.
2) Place the water container below the side water outlet behind the body.
3) Unscrew the drainage cover and unplug the water plug, the water will automatically flow into
the water container.
1. Keep the drainage cover and the water plug in a safe place.
2. During drainage, the body can be tilted backwards slightly.
3. If the water container gets too full, plug the water outlet with the water plug as soon as
possible to prevent water from flowing onto the floor or the carpet.
4 When the water has completely drained refit the water plug, and tighten the drainage cover.
Note. Restart the machine only after the water plug and drainage cover are installed, or
condensate water from the machine will flow onto the floor or the carpet.
Page 12