Warning Information - Napa Carlyle Tools 791-6005A Operating Manual

WARNING INFORMATION

This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the device owner to make sure all personnel read this manual prior to using the device. It is also the responsibility
of device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or
not legible, contact NAPA for replacements. If the operator is not fluent in English, the product and safety instructions shall be read to
and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator
comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of wheel dollies is subject to certain hazards that cannot be prevented by mechanical means, but only by the exercise of
intelligence, care, and common sense. It is essential to have personnel involved in the use and operation of the device who are careful,
competent, trained, and qualified in the safe operation of the device and its proper use when servicing motor vehicles and their
components. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly securing loads, overloading,
off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not intended.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study carefully, and understand the operating manual packed with this dolly before operating.
• Inspect the wheel dolly before each use. Do not use if damaged, altered, modified, in poor condition or unstable due to loose or
missing components. Make corrections before using.
• User and bystanders must wear eye protection that meets ANSI Z87.1 and OSHA standards.
• The use of this wheel dolly is limited to the removal, transportation and installation of wheel assemblies.
• Do not exceed rated capacity.
• Use only on a hard, level, dry concrete surface free from all obstructions.
• Before moving, lower the load to the lowest possible point.
• Apply load as close to the vertical portion of the lifting member as possible.
• Before moving the load, ensure the load is centered and secured with a load-restraint device.
• No alterations shall be made to this device.
• Always keep hands off vertical guide post when lowering elevator.
• Do not lift or support vehicles with wheel dolly.
• Do not use with tandem and duplex wheel and tire combinations.
• Do not use with tires that are wider than 12".
• Do not start the vehicle's engine or drive the vehicle when removing or installing wheel/tire combinations with a wheel dolly.
• When transporting a load, be sure not to make any sudden or abrupt stops as this may cause the telescopic lift arm assembly to
extend.
• Failure to heed these warnings may result in personal injury, property damage, or both.
WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer
and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
791-6005A
OPERATING MANUAL FOR 791-6005A
WARNING
2
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
12/18/18