Déclaration de CE-Konformitäts- EC declaration of conformité CE erklärung conformity Par la présente, nous Hiermit erklären wir, daß We hereby declare that this déclarons que cet dieses Aggregat folgenden unit complies with the einschlägigen Bestimmungen following relevant provisions: agrégat sitisfait aux entspricht: dispositions suivantes: EC machinery directive...
ENGLISH 1. General Information permitted for use within buildings, in other words not in the open air. Installation and service by qualified The pump must not be used for personnel only! pumping drinking water. 1.1 Uses The pump may not be used to drain swimming pools if people are in the The dewatering and dirty water submersible motor- driven pumps are used to automatically drain pits...
ENGLISH Dangers caused by electrical energy are to be water. excluded. Directives issued by the VDE [German Association of Electrical Engineers] and the local The motor is cooled by the surrounding pumping electricity supply companies are to be observed. medium. The pump is mounted on the bottom of a shaft.
ENGLISH 4.2 Products delivered ATTENTION! The minimum level (see fig. 1 and – Submersible motor-driven pump complete, table 1.2.2) may not be fallen short of. – Installation and operating instructions. 5.2 Electrical connection 4.3 Accessories Electrical connection should be made Accessories must be ordered separately.
The pump should therefore be serviced after approx. 2000 operating hours by a specialist or – Switching level adjustment of the float switch Wilo Customer Services, mainly in order to check The switching level (start-up point) can be altered the seals.
Dismantle suction strainer/ whirl device, rinse suction strainer / impeller under running water. If the fault cannot be remedied, please contact your plumbing and heating specialist or your nearest Wilo customer services or representative.
ENGLISH 9. Disassembly and assembly Disconnect power supply! Remove the mains plug! 9.1 Disassembly The suction strainer and whirl device are to be cleaned as required. It may also become necessary to clean the impeller. The following assembly stages are to be carried out: TMW: –...
Need help?
Do you have a question about the TM Series and is the answer not in the manual?
Questions and answers