Care And Maintenance - Hilti BX 3-BT User Manual

CAUTION
Risk of injury and risk of damage to the fastening tool. The use of unsuitable material and accessories
can lead to injuries and damage the fastening tool.
▶ Use only approved, genuine Hilti accessories with this tool.
1. Switch on the fastening tool. → page 20
2. Insert the threaded stud.
3. Hold the fastening tool perpendicular to the working surface, center the fastener guide, loaded with a
suitable threaded stud, over the pre-drilled hole and apply pressure to seat the fastener guide against
the working surface.
4. Drive the fastener by pulling the trigger.
5. Lift the fastening tool completely clear of the working surface after driving a fastener.
The fastening tool switches itself off automatically if the fastener guide is pressed against the
working surface for longer than 6 seconds without a fastener being driven. The fastening tool can
be switched on again by pressing the on/off button.
The fastening tool switches itself off automatically if it is not used for 6 minutes.
6.4 Switching off Bluetooth
▶ Press the on/off button for at least 5 seconds until the LED shows blue twice.
➥ No further data transfer is possible.
➥ Bluetooth is not available in all markets
Bluetooth can be deactivated if you are in a sensitive environment (e.g. a hospital) where use of
Bluetooth is prohibited.
7

Care and maintenance

7.1 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Switch off the fastening tool.
• Remove the battery.
• Remove the fastener from the fastener guide.
• Carefully remove any dirt that may be adhering to parts.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Care of the lithium­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
*2209576*
Printed: 20.09.2019 | Doc-Nr: PUB / 5514237 / 000 / 00
2209576 English 21