Operating In Manual Clean Rinse Mode - Whirlpool WHELJ1 How To Install, Operate And Maintain

Press the PROGRAM button twice, so "Fr TIME" appears in the display.
Press the UP or DOWN buttons to set the length of fast rinse in minutes.
Press the PROGRAM button again when complete.
Customizing Features I Options

OPERATING IN MANUAL CLEAN RINSE MODE

Clean Rinse cycles will run automatically, unless the automatic Clean Rinse function has been disabled. If
this function has been disabled, it will be necessary to manually initiate any Clean Rinse cycles. It is
recommended that a Clean Rinse cycle should be run at least once each month, or more frequently if
necessary.
A manual Clean Rinse mode may be used when a drain (required for automatic Clean Rinse) is not
available. However, it is recommended that automatic Clean Rinse be used if the drain requirements can
be met
IMPORTANT: During the Clean Rinse cycle, whether manually or automatically initiated, water will flow
from the valve drain port. If a permanent drain line has not been installed, provisions must be made for
the drain flow prior to initiating a Clean Rinse cycle.
DISABLING AUTOMATIC CLEAN RINSE
To disable the automatic Clean Rinse function:
Press and immediately release the CLEAN button (pressing and holding the button a few seconds would
initiate a Clean Rinse cycle).
"VAC" should flash in the display, indicating that the Central Water Filtration System is in the manual
Clean Rinse mode (the automatic Clean Rinse function has been disabled).
MANUALLY STARTING A CLEAN RINSE CYCLE To manually start a Clean Rinse cycle:
Press and hold the CLEAN button for a few seconds, until "RECHARGE NOW" flashes in the display.
When the Clean Rinse cycle is complete, the Central Water Filtration System will remain in the manual
Clean Rinse mode.
RE-ENABLING AUTOMATIC CLEAN RINSE
To return the Central Water Filtration System to its automatic Clean Rinse function:
Press and immediately release the CLEAN button.