Zumtobel SensControl Operating Manual page 14

Setting constant lighting control
Setting presence detection
4 EN
Tip
Stand next to the luminaire when setting the constant lighting control and make
sure that the sensor is not blocked.
Modifying the set value for constant lighting control
1. Press both keys simultaneously and hold for 8 seconds.
a LED lights up.
2. With single-channel version:
Press and hold upper key until the desired illuminance level is set.
a LED flashes rapidly until max. or min. value is reached.
3. Press both keys simultaneously and hold for 8 seconds to permanently save the
setting.
a The LED extinguishes.
4. With dual-channel version:
Press and hold upper key until the desired illuminance level is set for indirect light.
Press and hold lower key until the desired illuminance level is set for direct light.
a LED flashes rapidly until max. or min. value is reached.
5. Release the key and press and hold again to alternate the direction of adjustment.
6. Press both keys simultaneously and hold for 8 seconds to permanently save the
setting.
a The LED extinguishes.
Activating/deactivating constant lighting control
1. Press both keys simultaneously and hold for 8 seconds.
a LED lights up.
Briefly release both keys and press again simultaneously, holding for 5 seconds.
2.
a LED flashes slowly.
3. Press upper key 3 times to deactivate the constant lighting control.
- or -
Press upper key 4 times to activate the constant lighting control.
a LED flashes 3 or 4 times to confirm.
4. Press both keys simultaneously and hold for 8 seconds to permanently save the
setting.
a The LED extinguishes.
Modifying delay time or deactivating presence detection
1. Press both keys simultaneously and hold for 8 seconds.
a LED lights up.
2. Briefly release both keys and press again simultaneously, holding for 5 seconds.
a LED flashes slowly.
3. To set the delay time with the lower key:
• Press once for 10 seconds delay time (demo mode)
• Press twice for 1 minute delay time
• Press three times for 5 minutes delay time
• Press four times for 15 minutes delay time
• Press five times for 30 minutes delay time
• Press six times to deactivate presence detection
a LED flashes 1 to 6 times to confirm.
4. Press both keys simultaneously and hold for 8 seconds to permanently save the
setting.
a The LED extinguishes.
SensControl Lighting management
www.zumtobel.com