Modifying Settings - Zumtobel SensControl Operating Manual

SensControl Lighting management
Parameters and factory settings
Tip
Factory reset
To reset the factory
settings, pull out the
power plug and plug
in again with the
lower key held down.
a LED flashes once to
confirm.

Modifying settings

Article no.: 00109607/PC 01.17
The following parameters are available for individual adjustment of functions:
Parameter
Constant lighting control
Set value for constant
lighting control
Delay time
Automatic control
Lockout
Burning-in
Tip
If you do not press a key within a twenty second period during adjustment of
constant lighting control, presence detection, lockout or automatic control,
SensControl switches back to operating mode and the modifications are not saved.
If you have pressed keys erroneously, wait 20 seconds and repeat the adjustment.
Adjustable values
activated/deactivated
5 - 100%
10 seconds (demo mode),
1, 5, 15, 30 minutes,
Presence detection deactivated
semi-automatic/ fully
automatic
activated/deactivated
activated/deactivated
Factory setting
activated
15 minutes
fully automatic
activated
deactivated
3 EN