Zumtobel SensControl Operating Manual page 12

Installing the luminaire
Tip
In order to ensure
optional functionality
of the system, it must
be ensured that
sensors are aligned
towards the working
area during luminaire
installation.
Operating SensControl
Operation
Switch on luminaire
Switch off luminaire
Manually adjust illuminance
(dimming)
Burn-in mode
Factory reset
2 EN
SensControl Lighting management
Operation of SensControl is via keys on the luminaire. The functions of the keys differ
according to appearance:
Single-channel version
without separation of
indirect/direct light
p Press lower/upper key. p Briefly press upper key. p Briefly press lower key.
p Press lower key.
p Press and hold upper
key until the desired
illuminance level is set.
a LED flashes rapidly until max. or min. value is reached.
p Release the key and press and hold again to alternate the direction of adjustment.
The set value for constant lighting control is automatically restored following a
longer period of absence (at least 4 hours) or following a mains disconnection.
Pull out the power plug and plug in again with the upper key held down.
Pull out the power plug and plug in again with the lower key held down.
4 m
5 m
Dual-channel version
with separate indirect/direct light
Indirect lighting
p Press and hold upper
key until the desired
illuminance level is set.
During dimming take care not to press both keys
simultaneously, as in this case SensControl switches to
setting mode.
Direct lighting
p Press and hold lower
key until the desired
illuminance level is set.
www.zumtobel.com