TM
Fig. 9:
11.Install the module mounting plate (1) to the standoffs with the screws (2) and lock washers.
Make sure that all of the screws can be installed before tightening the screws all the way.
Fig. 10:
12.Connect the Display, Left Trunk connector (1) of the power to CAN X harness to the end of the
CAN Bus extension harness—40ft (2).
13.Route the shutoff adapter harness (3) connected to the boom signal transmitter module to the
back of the mounting plate.
©
2019 Capstan Ag Systems, Inc.
Installation—EVO
16
™
Upgrade Kit
EVO Upgrade Kit