Black+Decker AIRSWIVEL BDASL100 Series Instruction Manual page 14

Maintenance And Care - Replace Drive Belt
Maintenance And Care - Replace Drive Belt
WARNING:
WARNING:
maintenance to the vacuum cleaner.
maintenance to the vacuum cleaner.
Check the drive belt carefully for wear, cuts and stressed areas. If the drive belt Check the drive belt carefully for wear, cuts and stressed areas. If the drive belt
appears worn, you will need to replace it.
appears worn, you will need to replace it.
To remove the drive belt, read the instructions and follow the drawings below:
To remove the drive belt, read the instructions and follow the drawings below:
1. Use Phillips screwdriver to remove 6 screws from brushroll cover. Lift off cover.
1. Grasp the old drive belt and remove from motor shaft. Discard old drive belt.
2. Grasp the old drive belt and remove from motor shaft. Discard old drive belt.
2. Loop new drive belt over motor shaft and stretch other end over floor brush
in the space provided between the bristles.
3. Loop new drive belt over motor shaft and stretch other end over floor brush in the
4. Place ends of floor brush down into slots on sides as shown.
space provided between the bristles.
5. Turn floor brush by hand several times in the direction of the motor shaft.
4. Place ends of floor brush down into slots on sides as shown.
If properly installed, drive belt will align itself on floor brush.
5. Turn floor brush by hand several times in the direction of the motor shaft. If
6. Replace brush cover and six screws.
properly installed, drive belt will align itself on floor brush.
6. Replace brush cover and six screws.
1
3
Turn off and unplug vacuum cleaner before performing
Turn off and unplug vacuum cleaner before performing
2
4
14
14
Replace Brush Replace Brush
Cover and Cover and
Six Screws i Screws