Cisco UCS B200 M4 Servicing Manual page 21

Servicing a Blade Server
Step 2
Install the custom standoff in the same location at the back end of the motherboard.
Step 3 Position the GPU over the connector on the motherboard and align all captive screws to the standoff posts
(callout 1).
Step 4
Tighten the captive screws (callout 2).
Figure 18: Installing the NVIDIA M6 GPU
The following figure shows an NVIDIA M6 GPU installed in a Cisco UCS B200 M4 blade server.
Installing the NVIDIA M6 GPU Adapter Card
Servicing a Blade Server
21