Black & Decker ASI500 Original Instruction page 9

When the item is deflated or to stop the pump at any

time press the power switch (22) on the LCD.
Remove the high-volume hose ((7) from the item and

store it in the storage channel around the centre of
the unit.
Turn the main power switch (1) to the off

position (b fig. E).
Operating the LED light
To switch on the LED light (12):
Switch the main power switch (1) to the inflate (c fig. E)

or the pump (a fig. E) position.
Press either of the - or + buttons (21, 23) on the LCD (2)

to turn the LED light (12) on.
To switch the LED light (12) off:
Press either of the - or + buttons (21, 23) again.

Turn the main power (1) switch to off.

Sleep mode to preserve battery life
The unit is fitted with a sleep mode function that will help
prolong the life of the internal battery.
If the unit is left on and unused for more than two minutes the
unit will switch into sleep mode.
To power the unit again either switch the main power

switch (1) on and off or press any button on the LCD (2).
Note: After sleep mode, all settings will be lost and will need
to be re-entered following the instructions under the heading
'Setting the required pressure'.
Maintenance
Your Black & Decker corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper appliance/tool care and regular
cleaning.
Warning! Before performing any maintenance on corded/
cordless appliance/tool:
Switch off an unplug the appliance/tool.

Or switch off and remove the battery form the appliance/

tool if the appliance/tool has a separate battery pack.
Unplug the charger before cleaning it. Your charger

does not require any maintenance apart from regular
cleaning.
Regularly clean the ventilation slots in your appliance/

tool/charger using a soft brush or dry cloth.
Regularly clean the housing using a damp cloth. Do not

use any abrasive or solvent-based cleaner.
Regularly open the chuck and tap it to remove any dust

from the interior (when fitted).
Troubleshooting
Problem Possible cause
Inflator will not Internal battery
operate. fault.
12 Vdc adapter not
connected.
Accessory socket
not live.
Main ON/OFF
switch not in
correct position.
No preset value
set.
The fuse in the
12 Vdc adapter is
blown.
Cord or switch is
damaged.
Will not inflate. Incorrect mode
selected.
LCD not Unit in sleep
mode.
illuminated.
Replacing the fuse in the vehicle dc accessory plug
Remove the cap by turning it counter-clockwise.

Remove the cap and centre pin.

Remove the fuse.

Fit a new fuse of the same type and size (8A/250V).

Refit the cap and centre pin.

Tighten the cap by turning clockwise onto the plug.

Protecting the environment
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black & Decker product
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials.
ENGLISH
Possible solution
Recharge the
battery.
Connect the 12 Vdc
adapter.
Turn key to
accessory position
Turn main switch to
required position.
Set preset value.
Replace the fuse with
one of the same size
and type (8A/250V).
Have the cord or
switch replaced at a
Black & Decker
Service Centre or
Authorised Service
Centre.
Select correct mode.
Press any button on
LCD or the main on/
off switch.
9