Restore Default Settings; Upgrade Firmware Version - Waveshare RS485 TO ETH User Manual

RS485 TO ETH
Figure 4 Static IP/DHCP
2.1.2. RESTORE DEFAULT SETTI NGS
Hardware: User can press Reload over 5 seconds and less than 15 seconds then release to restore
default settings. Software: User can use setup software to restore default settings.
AT command: User can enter AT command mode and use AT+RELD to restore default settings.

2.1.3. UPGRADE FIRMWARE VERSION

User can contact to salespersons for needed firmware version and upgrade by setup software as
follow:
Figure 5 Upgrade Firmware Version