Advertisement
Troubleshooting
guide
Before
requesting
service
for this unit,
check
the chart
below
for
a possible
cause
of the problem
you are experiencing.
Some
sim-
ple checks
or a minor
adjustment
on your
part may
eliminate
the
problem
and restore
proper
operation.
If you are in doubt about some of the check
points,
or if the
remedies indicated
in the chart do not solve the problem, refer to
the directory
of authorized
service
centers (enclosed
with this
unit) to locate
a convenient
service
center,
or consult
your
Technics dealer for instructions.
(In U.S.A. consult
MSC Authorized
Servicenters
for detailed
in-
structions.)
I
Problem
Probable cause(s)
Changer will not play.
The disc in the changer
does not play.
Play stops before changing
to the next disc.
A certain music passage
can't be played correctly.
These is noise from the
tuner or disturbance
on the
TV screen.
When program play is
started,
an error message
(-E)
appears on the
display.
An error message (- E)
appears on the display, and
the changer
stops
operating.
The loading drawer stops in
the middle o! opening.
A disc(s)
or other
foreign
object(s)
has
fallen
inside
the changer.
Moisture
has collected
in the changer.
The disc is upside down.
The disc is dirty.
The disc is scratched.
]-he disc is warped.
The disc is not within specified
standards.
The loading drawer is open.
The disc
is dirty.
The disc
is scratched.
Caused
by high-frequency
signals
from
this
changer.
Play was started without a track being
programmed.
The mechanism
of the changer has been
improperly
adjusted.
Suggested remedy
• Open the loading drawer, and then remove the
object.
• Switch on and allow the changer to dry out for about
one hour before using it.
• Make sure the label is facing upward.
• Wipe the disc with a soft cloth.
• Replace the disc with a new one.
• Press the OPENtCLOSE button to close the loading
drawer.
• Wipe the disc with a soft cloth.
• Replace the disc with a new one.
• Use the changer
further away from the tuner or TV.
• If the tuner or TV's antenna is the indoor type, use an
outdoor one.
• Program a track.
• Turn the unit off and then back on again.
However,
if the loading drawer is fully open, take out
the compact
disc(s) at the front position and then turn
the unit off and then back on again.
I
Product
service
Do not attempt
to remove
the cover(s)
or repair the unit
yourself.
Refer servicing
to qualified
personnel only.
Product
information
For product service, product information
or assistance
in pro-
duct operation,
refer to the servicenter
directory.
19
Advertisement
