Honeywell HZ-420 Series Instructions Manual page 4

OPERATION
(CONTINUED)
Model HZ-420 Series - 360º Ceramic Surround Heater Operation
The Power Knob is equipped with two (2) heat settings:
1) Low ( ) – this setting uses 900 watts of power
2) High ( ) – this setting uses 1500 watts of power
NOTE: The Low ( ) setting does not require as much
electricity to operate. It is more energy efficient and may be
a better option if you are concerned about saving energy.
Turn heater on by turning the Power Knob to either Low
( ) or High ( ), the amber indicator light will come on.
To set the Thermostat, turn the Thermostat Control fully
clockwise to the highest (
When the room reaches a comfortable temperature, slowly
turn the Thermostat Control counter-clockwise until both the
heating element and fan go off (the amber Power Light will
remain on). This is the point at which the Thermostat setting
equals the room temperature. At this setting, the Thermostat
will automatically turn the heater back on and then off as needed to maintain the selected temperature.
Turn the Power Knob to OFF (
Model HZ-430 Series - EnergySmart
Turn heater on by pressing Power Button (
button. The heater will default to the Constant
HI mode and the Current Temp Indicator will
display the current room temperature.
The Energy Usage Indicator will display the power
consumption used by the heater.
• If HIGH, the heater is drawing 1500 watts
to quickly warm the room
• If LOW, the heater is drawing 900 watts
to slowly warm the room or maintain the
temperature
• If STAND BY, the heater is drawing no
power as the room has reached the Desired
Temperature
4
) setting.
) and unplug the heater when you are finished using it.
®
)
Model HZ-420
Thermostat
Control
Power
Knob
Power Light
360º Ceramic Surround Heater Operation
Model HZ-430
Energy Usage
Indicator
Current Temp
Indicator
Continuous
Heat Mode
EnergySmart
™
Thermostat
Mode
Timer
Power Button
Power Light