Inserting Batteries Into Remote Control; Set Up And Maintenance Of The Receiver; Protect Your Components From Overheating - THOMSON Scenium DPL4000 User Manual

Inserting Batteries into Remote Control

1. Press the part indicated and
push in the direction of the
arrow to open the battery
compartment door.
2. Insert two AA(LR06) batter-
ies according to the + and -
signs on the battery compart-
ment.
3. Press to close the cover.
To use the remote control,
point it directly at your
receiver.

Set up and Maintenance of the Receiver

IMPORTANT NOTE
• Provide spaces for sufficient ventilation as indicated
below. If the space is insufficient, the unit may over-
heat resulting in malfunction and shorter life time.
H O M E T H E A T E R A U D I O V I D E O R E C E I V E R D P L 4 0 0 0
10 cm/
ON/ECO
4"
MUTE
PHONES
5 cm/
2"
10 cm/4"
VOLUME
10 cm/
4"
OPEN/CLOSE
BASS/TREBLE LEVEL
L AUDIO R
VIDEO S-VIDEO
V-AUX 2
10 cm/4"
Getting Started
• Do not connect to the AC power cords until all
connections are completed.
• Do not use your set immediately after transferring
it from a cold place to a warm place: there is risk of
condensation.
• Do not expose your set to water and excessively
high temperatures.
• After having disconnected your set, clean the case
with a soft cloth, or with a slightly damp leather
chamois. Never use strong solvents.
Protect your Components from
Overheating
• Do not block ventilation holes in any component.
Arrange the components so that air can circulate
freely.
• Do not stack components directly on top of each
other.
• Allow adequate ventilation when placing your
components in a stand.
• Place an amplifier near the top shelf of the stand
so heated air rising from it will not affect other com-
ponents. If you have a satellite receiver, you should
place it on the top shelf.
EN
3