Table of Contents
Advertisement
DPL913VD-EN
receiver
10/26/04
2:22 PM
Page 2
THOMSON
46, quai Alphonse Le Gallo
92648 Boulogne
Cedex FRANCE
www.thomson.net
TOCOM
It is important to read this instruction book prior to using your new product for the first time.
Avant d'utiliser votre appareil pour la première fois, il est primordial que vous lisiez attentivement ce Guide d'Instructions.
Bevor Sie Ihr neues Produkt das erste Mal anwenden, müssen Sie unbedingt dieses Bedienhandbuch lesen.
È importante leggere attentamente questo manuale di istruzioni prima di utilizzare questo nuovo prodotto per la prima volta.
Es importante leer el libro de instrucciones antes de usar este nuevo producto por primera vez.
u s e r
m a n u a l
DPL913VD
Advertisement
Table of Contents
Related Manuals for THOMSON DPL913VD-RECEIVER
Summary of Contents for THOMSON DPL913VD-RECEIVER
- Page 1 DPL913VD THOMSON It is important to read this instruction book prior to using your new product for the first time. 46, quai Alphonse Le Gallo Avant d’utiliser votre appareil pour la première fois, il est primordial que vous lisiez attentivement ce Guide d’Instructions.
-
Page 2: Table Of Contents
......35-36 Inserting Batteries into Remote Control .3 CAUTION –... -
Page 3: Getting Started
10cm/4” DVD video - Digital video discs - 12 cm and 8 cm, single or dou- Front Rear bled sided, single or dual layer. DVDs are high-density optical discs on which high quality picture and audio are recorded by means of •... -
Page 4: Connecting To Audio-Visual Components
They must be hooked up in order to have clear reception. Setup video output You can select either S-video or SCART as your video output (default is SCART). Try power off the unit and turn it on again if you see any picture distortion on the TV. -
Page 5: Connecting The Speakers
(“out of phase” effect). 2 Center Do not ground the output line, it will cause damage to the In surround mode, the center speaker carries much of the speaker. dialogue as well as music and effects. It should be set between the left and right speakers. -
Page 6: Preferred Surround Placement
Even though you adjust the surround channel to be as loud No. 5,451,942; 5,956,674; 5,974,380; ter case, they can go right on the floor, or preferably, a few as the others on the test signal, you'll find that on actual 5,978,762;... -
Page 7: Operating Your Receiver
3. PR+, PR- • To select programmed stations in TUNER mode. 9. MENU • To skip to the next or previous chapter, track or image in DVD, CD, mp3 • Press to exit a menu. and JPEG mode. 15. INFO (Yellow) 4. -
Page 8: Display
Example 1: If you connect a MD player to the AUX 1 input on the receiver and press SOURCE until “AUX 1” shows on the display. You will be able to have the signal from the MD player. -
Page 9: Connection Of Audio Source
(See details in Source button Corresponding connector Surround. The Pro Logic II mode uses the built-in circuit to steer the Tuner section) (remote control) (receiver back panel) Left, Center, Right and Surround left and right channel 2. -
Page 10: Fine Setting Of Components
To test the speaker setting and change the speaker level In the TEST TONE menu, a short noise will come from each speaker respectively, press UP/DOWN to configure the cur- rently playing speaker. -
Page 11: Speaker Icons
Page 22 Advanced Sound Control Speaker Icons It is important to note, however, that not all Dolby Digital The receiver shows the speakers’ settings on the display sources are encoded with the full complement of five chan- with the following icons: nels plus subwoofer.
Need help?
Do you have a question about the DPL913VD-RECEIVER and is the answer not in the manual?
Questions and answers