Use
●
Measure and display the room temperature and humidity (depending on types)
●
Operate room functions such as fan control and room operating modes
●
Indicate open windows, room air quality, outdoor temperature, and outdoor humidity
Functions
Function of the display elements and push buttons
Elements
/
15.5 °C
/
/
25.0 °C
/
/
/
/
2
Siemens
/
/
/
/
/
Functions
●
A visible arrow Indicates an operable element
●
Temperature display in °C or °F / humidity in % r.h.
/ air quality in text, symbol, or ppm of CO₂
●
Toggling (button 1) between indoor and outdoor
measurement (temperature, humidity and CO₂)
●
Indicates that a window is open (connected window
contact is active)
●
Display of plant state (heating or cooling / inactive)
Note: No manual switchover!
●
Display of relative or absolute setpoint for
temperature
●
Adjust setpoint using buttons 2 and 6
●
Display of present fan speed (when automatic)
●
Adjust fan speed using button 3 (or buttons 3 and 7
if room operating mode operation is disabled)
●
Display of room operating modes (when automatic)
●
Adjust room operating mode using button 7
●
Navigation: Toggle display/setpoint setting between
temperature/humidity/CO₂ using button 4
●
Operation of occupancy state (presence switch,
Comfort extension)
●
Activate Comfort extension using button 8 (only
available if enabled)
●
Engineering functions (press buttons 1 and 8
simultaneously for 5s
- Programming mode (button 2), same function as
programming pin (service pin) on the rear of
device)
- Connection test (button 3) (not supported by ETS
and ACS)
- Reset device to factory settings (button 4)
Note: This operation is irreversible!
●
Indicates that the room operator unit is locked by
the system.
- Operation disabled
- Display in line 1 shows the temperature from bus
A6V10733768_en--_a
2017-07-28