Security
National safety regulations
Failure to comply with national safety regulations may result in personal injury and property
damage
●
Observe national provisions and comply with the appropriate safety regulations.
Engineering
●
The device offers plug & play functionality.
●
The device receives its power from the connected room automation station via the KNX
PL-Link interface, or from the jack connector.
●
Engineering and commissioning using the ABT (Automation Building Tool) tool and SSA
(Setup & Service Assistant) tool.
Mounting
●
The devices are suitable for wall mounting and panel mounting.
●
Recommended height: 1.50 m above the floor.
●
Do not mount the devices in recesses, shelves, behind curtains or doors, or above or
near heat sources.
●
Avoid direct solar radiation and drafts.
●
Seal the conduit box or the installation tube if any, as air currents can affect sensor
readings.
●
Adhere to allowed ambient conditions.
4
Siemens
CAUTION
A6V10733768_en--_a
2017-07-28