Table of Contents
Advertisement
Getting Started
Preferred surround placement
Location
If possible, place surround speakers to either side of the
listening area, not behind it.
Courtesy Dolby Laboratories
Height
If space permits, install surrounds 60cm-90cm (2-3 feet)
above viewers. This helps to minimize localization
effects.
Courtesy Dolby Laboratories
Aiming
Aiming surrounds straight across the room, not down at
viewers, helps create a more open, spacious surround
sound field.
Courtesy Dolby Laboratories
8
Advanced Setting
Alternative Surround Placement
Rear wall
If rear wall mounting is the only choice, aim the
speakers at each other (A), towards the front (B) or even
towards the sidewalls (C, D). Experiment with placement
until surround sounds seem to envelop you, rather than
coming from behind you.
Courtesy Dolby Laboratories
No adjacent walls
Surrounds can go on stands facing each other to
approximate the preferred sidewall mounting (A), or to
the sides or rear of the viewing area aimed upwards. In
the latter case, they can go right on the floor, or
preferably, a few feet off the floor such as on end tables
(B).
Courtesy Dolby Laboratories
Test Tone / Channel balance
Channel balance
Your receiver is equipped with a test signal generator
for balancing the channels. As the signal "travels" from
channel to channel, adjust the level controls until each
channel plays at the same loudness level.
Courtesy Dolby Laboratories
To activate and adjust test tone, refer to "Testing
Speaker Loudness" under the "Advanced Sound
Control" section (Pg 20).
Level adjustment & surround channel
level expectation
Even though you adjust the surround channel to be as
loud as the others on the test signal, you'll find that on
actual program material the surround channel is usually
much lower than the front. Don't be tempted to
readjust the surround level; program producers use
surround mostly for subtle atmospheric and ambience,
and only rarely for special effects. A good surround mix
doesn't call attention to itself; if it did, it would soon
become distracting.
NOTE
The system is equipped with Dolby Digital,
and manufactured under License from Dolby
Laboratories.
Getting Started
Dolby Digital
Manufactured under license
from Dolby Laboratories.
"Dolby", "Pro Logic" and
the double-D symbol are
trademarks of Dolby
Laboratories. Copyright
1992-1997 Dolby
Laboratories, Inc. All Rights
Reserved.
Manufactured under license from
Digital Theater Systems, Inc. US Pat. No.
5,451,942, 5,956,674, 5,974,380,
5,978,762 and other world-wide patents
issued and pending. "DTS" and "DTS Digital Surround"
are registered trademarks of Digital Theater Systems,
Inc. Copyright 1996, 2000 Digital Theater Systems, Inc.
All Rights Reserved.
Factory Setting
The unit is preset to the following settings when you
first power the receiver up right out of the box:
Function = TUNER
Volume setting = 25
Bass & treble = 0 dB
EQ = FLAT
Speaker settings: Center, surr = YES
Subwoofer = STRONG
DRC = OFF
NOTE
STRONG SUBWOOFER setting makes the
output level of subwoofer speaker to be
stronger than normal Dolby setting. Adjust
the SUBWOOFER setting by pressing the
SUBWOOFER key to achieve the best bass
performance.
You may restore factory setting with the following
procedures:
1. Enter SAT mode.
2. Press PRESET UP, PRESET DOWN, SOURCE to
reset the unit.
All preset stations will reset to FM87.5MHz and all
receiver settings restore to default settings as described
above.
WARNING
All preset radio stations and surround
sound settings will be lost after factory
setting is restored.
EN
9
Advertisement
Table of Contents
