Installation; Sleep; Altitude; Lamp Power - Panasonic PT-AE2000E Operating Instructions Manual

INSTALLATION

When installing the projector, select the projection
method according to the projector position. Press I H
to cycle through the options. See "Projection method" on
page 15.
Setting on a desk/floor and
FRONT/DESK
projecting from front
Mounting in the ceiling and
FRONT/CEILING
projecting from front
Setting on a desk/floor and
REAR/DESK
projecting from rear
Mounting in the ceiling and
REAR/CEILING
projecting from rear

SLEEP

You can select the required duration of time and set the
off timer to turn off the power of the projector
automatically. 3 minutes before turn-off, the countdown
of minutes will be displayed in the lower right corner.
Press I H to cycle through the options. See "Switching
off the projector automatically" on page 25.

ALTITUDE

If you use the projector at high elevation, the ALTITUDE
setting need to be HIGH to set the fan speed high. Press
I H to select the required option.
LOW The fan speed is low.
HIGH The fan speed is high.
NOTE:
• At 1 400 m (4 593 ft) above sea level, the setting must
be HIGH.
• The loudness of fan noise depends on the ALTITUDE
setting.

LAMP POWER

You can adjust the power of the lamp to save on
electricity, prolong the lamp life and reduce the noise.
Options
When higher luminance is
NORMAL
required.
When lower luminance is
ECO-MODE
sufficient.
NOTE:
• When no input signal is detected, the function is
disabled.

LAMP RUNTIME

You can check how long the lamp has been used.
NOTE:
• LAMP RUNTIME is a relevant matter for lamp
replacement timing. See "Replacing the lamp unit" on
page 44.
OPTION menu
Function
E
NGLISH - 41