3.1
Connecting a Computer Using the Ethernet Cable
Requirements
>
Your computer must have a free Ethernet port.
>
Your computer must be configured to obtain an IP address automatically. This is the default setting.
Ethernet cable
In your package, you will find a cable with yellow connectors. This is the Ethernet cable.
Procedure
Proceed as follows:
1
Connect one end of the Ethernet cable to (one of the) yellow Ethernet port(s) of your Thomson Gateway:
2
Connect the other end of the Ethernet cable to your computer.
3
Your computer is now connected to your network. No additional configuration is needed.
20
Adding a New Computer to your Network
1
2
3
2
1
ON/OFF
Reset
Ethernet
4
3
4
DSL
E-DOC-CTC-20080627-0003 v1.0
Chapter 3