Advertisement
Figure 3
Setting S1 on the ANN-1 Board
To assemble the MBK-RK:
1. Remove the four screws from the four
standoffs on the rear side of the MKB-RK
plate.
2. Position the MKB-3 panel over the four
standoffs on the rear side of the MBK-RK
plate, being sure that the MKB-3 panel fits
into the cutout on the plate.
3. Replace the four screws on the standoffs and
tighten them securely.
4. Mount the MKB-RK to its recommended
location on the rack. Refer to Table 1 and
Figures 6 and 7 to determine the correct
location for your system.
TSP-40 Installation
The TSP-RK has two components:
1. U-shaped plate with studs (See Figure 4).
2. A dress plate with a clear lens.
To assemble the TSP-RK:
1. Mount the TSP-40 printer to the studs using the
hardware and installation instructions
supplied with the printer. In this application,
use the instructions for mounting the TSP-40
in an MBR-1 backbox.
2. After installing the printer to the plate, mount
the plate to the rack using hardware supplied
with the rack. Refer to the SYSTEM
ASSEMBLY section below and Figures 6
(with Voice) and 7 (without Voice), for the
recommended location on the rack.
3. Mount the dress plate onto the rack with the
clear lens centered over the printer paper.
Fasten in place using hardware supplied with
the rack.
SYS-RK Installation
The SYS-RK has two components (See Figure 5):
1. An 8
3
/
X 19" plate with studs.
8
2. A U-shaped plate with studs.
To assemble the SYS-RK:
1. Mount the 8
3
/
X 19" plate on the rear of the
8
rack. Refer to the SYSTEM ASSEMBLY
section and Figure 6 for the recommended
location on the rack.
2. Place the six holes in the U-shaped plate over
the six studs in the 19" rack plate. Secure the
U-shaped plate in place using the six 8-32
nuts provided.
3. Install the EL-410D over the four studs on the
U-shaped plate using the four 8-32 nuts
provided.
TSP-RK U-shaped Plate with Studs
4
STUDS
Figure 4
Advertisement
