Reset To Factory Defaults - THOMSON SpeedTouch 585 User Manual

5.3 Reset to Factory Defaults

Resetting your
SpeedTouch™
Software reset
Hardware reset
E-DOC-CTC-20051017-0147 v2.0
You might consider a reset to factory defaults as described below.
Be aware that a reset to factory defaults will revoke all configurational
!
changes you made to the SpeedTouch™.
You can choose between:
Software reset
Hardware reset
A reset to factory default settings deletes the configuration profile settings.
Therefore, after the reset, a reconfiguration of your SpeedTouch™ will be needed.
Also your WLAN clients will have to be re-associated, as described in
"2.2.2 Connecting Wireless Clients for the First Time" on page
Proceed as follows:
1
Go to the SpeedTouch™ Web pages.
2
In the menu, select SpeedTouch > Configuration.
3
In the Pick a task list, click Reset my SpeedTouch to default settings.
The SpeedTouch™ restarts.
4
The SpeedTouch™ returns to the SpeedTouch™ home page (unless the IP
address of your computer is not in the same subnet as the default IP address
of the SpeedTouch™, being 192.168.1.254).
Proceed as follows:
1
Make sure the SpeedTouch™ is turned on.
2
Use a pen or an unfolded paperclip to push the recessed reset button on the
back panel. The reset button is marked with a red circle. Push it until the power
LED lights red - this will take about 7 seconds.
ON/OFF Reset
1 2 3 4
2
1
Ethernet
Chapter 5
Troubleshooting
20.
3
4
DSL
99