THOMSON HP 270 User Manual page 7

6
EN
How To Attach The Strap
1 Thread one end of the strap through the
eyelet, then pass the other end through the
loop.
2 Attach the screw to the tripod mounting
socket. To tighten the screw firmly, use a
coin, etc.
3 Adjust the length with the adjuster.
NOTES:
You can use the strap as a shoulder strap by
adjusting the length with the adjuster.
Because a loose screw may cause damage to the
camcorder, make sure to tighten the screw firmly to
the tripod mounting socket when carrying the
camcorder.
Use the strap only with this camcorder.
Do not grip the camcorder too firmly when the
screw is attached. Doing so may cause damage to
the tripod mounting socket.
How To Attach The Core Filter (for optional USB cable)
Attach the provided core filter to an optional USB cable. The Core Filter reduces interference.
1
Stopper
Release the
stoppers on both
ends of the Core
Filter.
When connecting cables, attach the end with the Core Filter to a PC.
2
3 cm
Run the cable through the Core Filter, leaving approx.
3 cm of cable between the cable plug and the Core
Filter. Wind the cable once around the outside of the
Core Filter as shown in the illustration.
•Wind the cable so that it is not slack.
NOTE:
Take care not to damage the cable.
1
3
Wind once
Close the Core Filter until it
clicks shut.
2
3