Getting Started; Using Ac Power - THOMSON HP 270 User Manual

10
EN
1
Notches
2
ATTENTION:
Before detaching the power source,
make sure that the camcorder's power
is turned off. Failure to do so can result
in a camcorder malfunction.
To AC outlet
AC Power
Adapter/Charger
To battery
pack mount
BATT. RELEASE Switch
Power cord
To DC OUT
terminal
DC cord

GETTING STARTED

USING THE BATTERY PACK
1
Insert the terminal end
battery pack mount, then firmly push the end
the battery pack in the direction of the arrow until it
locks into place as shown in the illustration.
•To attach the battery firmly, align its two notches
with the tabs on the camcorder.
To Detach The Battery Pack. . .
.... while sliding down BATT. RELEASE, detach it.
Approximate recording time
Battery pack LCD monitor on/
Viewfinder off
BPD270
NOTES:
Recording time is reduced significantly under the
following conditions:
• Zoom or Record-Standby mode is engaged repeatedly.
• The LCD monitor is used repeatedly.
• The playback mode is engaged repeatedly.
Before extended use, it is recommended that you
prepare enough battery packs to cover 3 times the
planned shooting time.

USING AC POWER

Use the AC Power Adapter/Charger (connect as shown in
the illustration).
NOTES:
The provided AC Power Adapter/Charger features
automatic voltage selection in the AC range from 110 V
to 240 V.
For other notes,
1
of the battery pack into the
LCD monitor off/
Viewfinder on
1 hr. 1 hr. 10min.
pg. 75.
(cont.)
2
of