Mobile Phone Software Operation Instructions; Introduction To The Interface; Connections - Alpine PXE-X09 Manual

Mobile Phone Software Operation Instructions

An iPhone user may search PXE-X09 Tuning App in the APP Store
to download and install it; an Android user may directly scan the
QR Code on the front cover to download and install it.
Start the PXE-X09 device when PXE-X09 APP is successfully
installed on a mobile phone. Open the "Setup" screen on the mobile
phone → "Start Bluetooth" → "Search device" → "DSP-HD-...",
click to connect. Or directly open the mobile phone software for
PXE-X09 to search Bluetooth automatically. Click to connect
"DSP-HD-...". The display of 100% data synchronization means a
successful connection.
Now, when you open the mobile phone software for PXE-X09, the
unit will be connected automatically. Enter the Alpine screen ->
Carefully read the disclaimer, and click "Accept" to enter the
homepage.

Introduction to the interface

There are 3 control interfaces for different functions, i.e. Input,
Homepage, and Output. The default is to enter the Homepage
screen.
Homepage
Mobile Phone Software
Input

Connections

1. When the Bluetooth icon [
phone Bluetooth is not connected; when it shows a green color,
the mobile phone Bluetooth is connected.
2. Click [ ] to proceed the operations including [Mixer],
[Signal Generator], [Input Debugging Setting], [Output
Debugging Setting], [Turn-off Delay], [Configuration Wizard],
[Encryption], [Share Sound Effect], [Save Sound Effect],
[Local Sound Effect], [About] and [Exit].
a. Choose [Mixer] to enter the mixer setup screen to adjust
the volume of each audio source in the channels for the
purpose of audio or frequency mixing.
b. Choose [Signal Generator] to test
whether the output signal works well
when no music is playing. When
"Generator Output" is chosen as output
signal, the signal has pink noise, white
noise, sinusoid or sine wave (positive
half cycle). The adjustable range of
volume: -60dB~0dB; the adjustable
range of frequency: 20Hz~20kHz. The
output is music when you choose music
output as the output signal. The default is music output.
c. Choose [Input Debugging Setting] to set the input
functions to be debugged, where five options are available,
i.e. Channel EQ, Crossover, Channel Phase, Channel
Volume and Channel Mute.
Output
] shows a red color, the mobile
5