Satellite Or Cable Receiver; G-Link Cable - Adjusting Your Dth 8000'S Ir (Infrared) Controller Cell - THOMSON DTH8000 Owner's Manual

DTH8000_en(EB-UB)

Satellite or cable receiver

Your DTH 8000 is designed to control either a cable or satellite receiver, this enables you to
program the recording of satellite programmes simply by programming your DTH 8000.
In this case, the device must be connected to the AV2 and IR SAT/CABL connections of the DTH 8000.
Connect cables (5) (not supplied) and cable (6) the G-LINK cable (supplied) as shown below.
Note: In grey: connections already carried out (connections from page3),
In black: new connections.
DTH 8000

G-LINK CABLE - Adjusting your DTH 8000's IR (infrared) controller cell

You need to find the correct positioning of the IR controller cell in relation to the front of the
satellite or cable receiver so that your DTH 8000 can transmit the commands as you would do
with the satellite receiver's remote control.The IR (infrared) controller cell must face the receiver
cell of the satellite receiver.You can locate the receiver cell of the satellite receiver by bringing its
remote control as close as possible to the front of the device and trying to change channels.
Move the remote control one centimetre and try again.When the channel of the satellite receiver
changes, locate the position on the front of the unit.Then install the IR controller cell as shown
on the diagram below, facing the cell of the satellite receiver (1 or 2 cm away). If need be, use the
adhesive supplied to stick the cell in place.
IR controller cell
18/12/03 14:48 Page 9
Connections and initial set up
5
Satellite receiver
6
Satellite or cable receiver
9
TV set
EN
EN