For Your Safety; Dvd Copy Protection; Remote Control - Code A-B; Technical Data - THOMSON DTH8000 Owner's Manual

DTH8000_en(EB-UB)

For your safety

Never open the player or any of its components. It can be dangerous for you or for certain fragile
components.You could receive an electric shock or touch the laser beam. Do not place your eyes
close to the opening of the disc tray or any other opening to look inside the player.

DVD copy protection

In accordance with the DVD standard, your DTH 8000 is equipped with a Copy Protection
system, which can be triggered on and off by the DVD disc itself, in order to make any recording
of the concerned DVD disc onto a videotape of very poor picture quality, or even impossible.
"This product incorporates copyright protection technology that is protected by method claims
of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation
and other rights owners. Use of this copyright protection technology must be authorized by
Macrovision Corporation, and is intended for home use only unless otherwise authorized by
Macrovision Corporation. Reverse engineering or disassembly is prohibited."

Remote control - Code A-B

Remote control setting on code B
No. to key in
3000
Code A
3001
Code B
1. Press and hold the
2.
With the number keys, press
3. Release the
DTH 8000 setting on code B
1.
Switch on your DTH 8000.
2. Check that there is no disc in the disc tray.
3.
Simultaneously press the
release them when your DTH 8000 displays
4. Try to control your DTH 8000 with the remote control.
Note: in the event of a problem, redo the setting of both components:
the remote control and your DTH 8000.

Technical data

Power requirements 220 to 240 V - 50/60 Hz
Power consumption 36 W when ON (approx.) < 3 W in the eco mode.
Functioning conditions +5°C to + 35°C surrounding humidity: 80 % maximum
Playback system Laser diodes - Wave length: 655 / 780 nm, Laser power CLASSE 2
Reception norms LL' - BG - I - DKK'
Number of storable channels 99
Remote control Infrared 33 Khz - Batteries 2 x 1.5 V (AAA)
Nominal Specification - THOMSON reserves the right to change the specifications without notice.
18/12/03 14:49 Page 59
On display panel Note: The remote control of your DTH 8000 is set to code A
DVD A
(3000). To set it to code B (3001) follow the procedure
DVD B
described below.
key.
DVD
3 , 0 , 0 , 1
key.
DVD
PAUSE , PLAY
Further information
.
, AV buttons at the front of your DTH 8000 and
DVD B
.
59
EN
EN
DTH 8000 EB/UB - EN / RST - BEI / 12-2003