FujiFilm EC-3000 Manual page 7

1. Install the Shoulder Unit with the
back-rest at the upright
position.
3. Fix securely at two places with a pair
of mounting screws.
Request
Install in the same way also at the opposite side.
When disassembling, proceed referring to the
installation method.
1. Install the Arm Unit with the back-rest
at the upright position.
3. Press down the Arm
Unit a click sound
can be heard.
Request
Install in the same way also at the opposite side.
When disassembling, proceed referring to the
installation method.
Preparation Before Use
Installation of the Shoulder Unit.
Mounting screw
Hexagonal
wrench
* In tightening the mounting screw, use fingers
first until it reaches the innermost. When you
find it difficult to tighten it, try to press the
Shoulder Unit with hand. With the screw at
the innermost, fix it with the hexagonal wrench.
Installation of the Arm Unit.
4. When removing the Arm Unit, insert the hexagonal
wrench in the hole.
Pull it upward while
pressing the button.
* The hole of the Arm Unit
at the opposite side is on
the back-rest.
6
2. Insert the Shoulder Unit convex and
the air joint in the hole on the
back-rest.
Holes
4. It is complete once the cap has been
installed.
CAUTION
Make sure to install the Shoulder Unit securely. Otherwise,
it could cause air leakage or injury or mechanical trouble if
the unit has dropped off accidentally.
2. Insert the Arm Unit convex into the
hole of arm-rest.
Arm Unit
Convex
* Arm Units are
identical at
right and left.
Arm
Unit
Back-rest side
Hexagonal wrench
CAUTION
Make sure to install the Arm Unit securely. Otherwise, it
could cause air leakage or injury or mechanical trouble if
the unit has dropped off accidentally.
Shoulder Unit
Convex
Air joint
Cap
Holes
Button
Locking mechanism
enlarged
Hole*