Connections - THOMSON DTH 2000 User Manual

Audio connections
* The type of audio output from
the connector you can select
during the set-up procedure
(see page 25).
** The player converts sound
having 96 kHz sampling, into
48 kHz sampling before it is
output from the unit's optical /
coaxial digital audio output
connector.
• Linear PCM is a signal recording
format used in CDs. While CDs
are recorded in 44.1 kHz /
16 bit, DVDs are recorded in
48 kHz / 16 bit up to 96 kHz /
24 bit.
Angle / rating
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Languages
. . . . . . . . . . . . . . . . . . . . . . .
When connecting the optical
audio digital cable:
The audio output from the unit's optical / coaxial
digital audio output connector
DVD
Video CD MPEG1
CD
18 Audio CD / video CD specials
19 / 22-23 Basic set-up
. . . . . . . . . . . . . . . . . . . . .
Sound recording on the
disc
Dolby Digital
(AC-3)
Linear PCM (48 / 96 kHz
16 / 20 / 24 bit
MPEG2
Linear PCM
This player's digital audio (optical and coaxial)
output jacks:
fully comply with the international standard governing this type of
jack (IEC 958). They are designed exclusively for connection to a
Dolby Digital (AC-3) or MPEG2 audio receiver or a suitable
decoder.
Do not use ...
the Digital Audio Output jacks to connect to an equipment other
than a Dolby Digital (AC-3) or MPEG 2 receiver or a suitable
decoder.
Such a connection can create a high level of noise that may be
harmful to your ears, and could damage headphones or speakers.
Older digital equipment, some of which is not fully compliant
with IEC 958, is likely to cause this problem.
The same should be applied with the so-called "optical or coaxial
REC.OUT jack" of Dolby Digital (AC-3) decoders, when they are
connected to this DVD player. Since REC.OUT is a 1:1 copy of
the decoder's input, no other equipment should be connected
there.
20-21 Universal remote control
. . . . .
4-5, 22-25 What to do if... / Index
1. Remove the dust protection cap
from the connector and connect
it firmly as shown on the
drawing.
2. Keep the dust protection cap and
always reattach the cap when
not using the connector, to
protect against dust.
Digital audio output from
optical / coaxial connector
Dolby Digital bitstream
(2 – 5.1 channels) or
linear PCM (2 channels,
48 kHz / 16 bit) *
Linear PCM (2 channels,
48 kHz sampling / 16 bit
only), or no output **
MPEG audio bitstream or
linear PCM (2 channels,
16 bit) *
Linear PCM
(44.1 kHz sampling)
Linear PCM
(44.1 kHz sampling)
30-33
. . . . . . . . . . .
42-45
. . . . . . . . . . . . . .
37